Bochi Machine Tool Group Co. CS6140 Series, Руководство оператора

Страница: 5 / 77

CS6140, CS6140B Series Turning Machine Instructions
1-2
when operating.
18
）
The machine was inspected carefully before shipment from factory. Its noise emission is not higher than
81dB. Wear suitable personal protective equipment when necessary, for instance, wear hearing
protection to reduce the risk of induced hearing loss.
19
）
Provide adequate light around the machine, and keep the perimeter around the machine dry, clean and in
good order. In addition, do not place anything near the machine; otherwise it becomes an obstacle during
operation.
20
）
Do not move away any guard during all working.
21
）
Isolate the machine from the power sources when leaving the machine.
22
）
Restart the machine only after the guards and safety devices are replaced to their position.
23
）
Do not place tools, work-pieces or other items on the machine, especially on the moving parts.
24
）
Do not start the spindle unless the workpiece is clamped completely in the chuck, and the key is taken
away from the chuck and the chuck guard is closed.
25
）
When chucking an irregular-shaped workpiece, make some adjustments to center of its gravity so that the
workpiece can rotate steadily.
26
）
Stop the machine before adjusting the position of the coolant nozzles.
27
）
Avoid as much as possible, using compressed air to remove dust and chips etc. deposited on the
machine, switchboard, NC controller etc.
28
）
The fixtures to be set on the machine must have sufficient rigidity and proper steps should be taken so that
the surface of the fixtures will be slip-free.
29
）
Both operators and the maintenance men should read with care the description on the caution plate
attached to the machine. They should observe the precautions on this plate during their work. During
operation and maintenance, care should be used so that this caution plate is not dirtied or damaged..
30
）
Memorize where the emergency stop push button is so that it can be depressed without delay in case of
an emergency.
31
）
Follow the starting procedures given in this manual to start the machine.
32
）
Keep your hands away from the moving parts of the machine during operation.
33
）
Do not get direct access to the work light when it is on. That may cause being scalded.
34
）
Never remove chips from machine during operation. Especially do not handle chips with hands.
35
）
When removing chips caught around the turret or deposited on machine, take them out with a tool instead
of hand, because your hand may be injured. Be sure to stop the machine when removing chips from it.
36
）
Prior to starting test operation, carefully read this manual so as to be completely familiar with this machine.
37
）
Contact this company if for some reason the manual should become unreadable.
38
）
When setting up a tool, stop the spindle and the feed in each axis.