BMW Z4 Roadster, Руководство пользователя

Страница: 236 / 344

▷ Hand-held transmitter arrow 3; required for
programming.
Programming
General
The battery in the hand-held transmitter must be
fully charged during programming to ensure the
integrated universal remote control will have the
optimum range.
1. Switch on standby state.
2. Initial operation:
Simultaneously press and hold the two outer
buttons on the rear-view mirror for approxi‐
mately. 10 seconds until the LED on the rear-
view mirror flashes green rapidly. All current
programming for the buttons on the rear-view
mirror is deleted.
3. Press the button on the rear-view mirror to be
programmed. The LED on the rear-view mir‐
ror flashes orange slowly.
4. Hold the hand-held transmitter for the system
to be operated approximately 2.5 to 30 cm, 1
to 12 in away from the buttons on the rear-
view mirror. The distance required depends
on the hand-held transmitter.
5. Press and hold the button for the desired
function on the hand-held transmitter.
6. ▷ The LED is illuminated green: program‐
ming is complete.
Release the button.
▷ The LED flashes rapidly: programming is
not complete.
Press and hold the button on the rear-
view mirror for 2 seconds, then release.
Repeat this process three times to com‐
plete programming.
If the integrated universal remote control
is still not operational, continue from Spe‐
cial instruction for alternating-code radio
systems.
▷ The LED does not flash green after
60 seconds: programming could not be
completed.
Repeat steps 3 to 6.
To programme other functions on other buttons,
repeat steps 3 to 5.
Special instruction for alternating-
code radio systems
If the radio-controlled system cannot be oper‐
ated after repeated programming, check whether
the system to be operated is equipped with an
alternating-code radio system.
To do that, look this up in the user manual of the
system.
For systems with an alternating-code radio sys‐
tem, the integrated universal remote control and
the system must also be synchronised.
Please find information on synchronisation in the
user manual of the system to be set.
To make synchronisation easier, enlist the assis‐
tance of a second person.
Synchronise integrated universal remote control
with system:
1. Park your vehicle within the range of the radio
remote-controlled system.
2. Programme the corresponding button on the
rear-view mirror as described.
3. Locate and press the synchronisation button
on the system being set, for example on the
garage door. The next step must be carried
out within approximately 30 seconds.
4. Hold down the programmed button on the
rear-view mirror for 3 seconds and then re‐
lease. Repeat this step as needed up to three
times to complete synchronisation. When
synchronisation is completed, the program‐
med function is run.
Seite 236
CONTROLS
Interior equipment
236
Online Edition for Part no. xxx - X/18