BMW 5 SERIES - CATALOGUE, Руководство пользователя

Страница: 276 / 337

▷ After the tire inflation pressure has been
adjusted.
▷ After a tire or wheel replacement.
Reset
Using iDrive:
1. "My Vehicle"
2. "Vehicle status"
3. "Tire Pressure Monitor"
4. Switch on drive-ready state and do not
drive off.
5. Reset tire inflation pressure: "Perform
reset".
6. Drive away.
The wheels are displayed in gray and the fol‐
lowing is displayed "Resetting Tire Pressure
Monitor…".
After driving faster than 19 mph/30 km/h for a
short period, the set tire inflation pressures are
accepted as the target tire inflation pressures.
The reset is completed automatically while
driving.
After a successfully completed reset, the
wheels on the Control Display are shown in
green and the following is displayed: "Tire
Pressure Monitor active. See label for
recommended pressures.".
You may interrupt this trip at any time. When
you continue the reset resumes automatically.
Messages
Required tire inflation pressure check
message
A Check Control message is displayed.
Possible causes:
▷ Inflation was not carried out according to
specifications, e.g., the tire has not been
sufficiently inflated.
▷ The tire settings were not updated.
▷ For tires with special approval:
▷ The system has detected a wheel
change, but no reset was done.
▷ The tire inflation pressure has fallen
below the level of the last reset.
▷ No reset was performed for the sys‐
tem. The system issues a warning
based on the tire inflation pressures
stored during the last reset.
In these cases:
1. Check the tire pressure and correct as
needed.
2. ▷ Update the tire settings.
▷ For tires with special approval: perform
a system reset.
Message in case of low tire pressure
The yellow warning light lights up.
A Check Control message is displayed.
Possible causes:
▷ There is a tire inflation pressure loss.
▷ For tires with special approval: a system
reset was not performed. The system is‐
sues a warning based on the tire inflation
pressures stored during the last reset.
In these cases:
1. Reduce the vehicle speed. Do not exceed a
speed of 80 mph/130 km/h.
2. At the next opportunity, for instance at a
gas station, check the tire inflation pres‐
sure in all four tires and correct if neces‐
sary.
3. For tires with special approval: perform a
system reset.
Seite 276
Mobility Wheels and tires
276
Online Edition for Part no. 01 40 2 976 346 - X/16