BMW 5 SERIES - CATALOGUE, Руководство пользователя

Страница: 272 / 337

If a tire inflation pressure of at least 2 bar
cannot be reached, contact your dealer’s
service center or another qualified service
center or repair shop.
If a tire inflation pressure of at least 2 bar is
reached, see Minimum tire inflation pres‐
sure is reached.
6. Unscrew the connection hose of the com‐
pressor from the tire valve.
7. Pull the connector out of the power socket
inside the vehicle.
8. Stow the Mobility System in the vehicle.
Minimum tire inflation pressure is
reached
1. Stow the Mobility System in the vehicle.
2. Immediately drive approx. 5 miles/10 km to
ensure that the sealant is evenly distrib‐
uted in the tire.
Do not exceed a speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
Adjustment
1. Stop at a suitable location.
2. Screw the connection hose of the com‐
pressor directly onto the tire valve stem.
3. Insert the connector into the power socket
inside the vehicle.
4. Correct the tire inflation pressure to at
least 2.0 bar.
▷ To increase pressure: with standby
state switched on or the engine run‐
ning, switch on the compressor.
▷ To reduce the pressure: press the but‐
ton on the compressor.
5. Unscrew the connection hose of the com‐
pressor from the tire valve.
6. Pull the connector out of the power socket
inside the vehicle.
7. Stow the Mobility System in the vehicle.
Continuing the trip
Do not exceed the maximum permissible
speed of 50 mph/80 km/h.
Reinitialize the Flat Tire Monitor, refer to
page
279 .
Reinitialize the Tire Pressure Monitor, refer to
page
273 .
Replace the nonworking tire and the sealant
container of the Mobility System promptly.
Snow chains
Fine-link snow chains
The manufacturer of your vehicle recommends
use of fine-link snow chains. Certain types of
fine-link snow chains have been tested by the
manufacturer of the vehicle and recommended
as road-safe and suitable.
Seite 272
Mobility Wheels and tires
272
Online Edition for Part no. 01 40 2 976 346 - X/16