Blue Coat SG810 series, Руководство по установке

Страница: 34 / 110

P/N 231-02941 SG810 Installation Guide page 34
Section C: Initial Configuration Using a Serial Console
This section describes how to configure the SG810 using a direct serial port
connection.
A PC, serial terminal, or a stand-alone serial console terminal can be used to
configure an SG810 the first time you power it on. Use the serial console setup to
configure the following basic network information:
You can also configure a bridge or a forwarding host, or you can restrict access to
the SG810
to a particular IP address or set of IP addresses.
PC Note: If the PC is using standard serial port settings, you should have
a problem-free connection. You can run into problems, though, if
there are non-standard PC serial port settings.
• IP address • Subnet mask
• Gateway address • DNS address
• Console username
and password
• Enable password