Blue Coat SG810 series, Руководство по установке

Страница: 56 / 110

P/N 231-02941 SG810 Installation Guide page 56
5
At the command prompt, enter
enable
, then enter the enable password that
you wrote down or configured during initial configuration:
SGOS> enable
Enable Password:
SGOS#
You are now in privileged mode.
6
At the privileged-mode command prompt, enter
configure terminal
to
configure SG810 settings:
SGOS# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
SGOS#(config)
Refer to the Blue Coat ProxySG Configuration and Management Guide for
information about configuring and administering the ProxySG.
To log in to the SG810 CLI using an SSH client:
1
Start the ProxySG.
Note: You must already have an SSH Client installed before you proceed
with the steps below.
2
Launch your SSH Client—enter the following settings as necessary:
• The IP address that you configured during initial configuration.
• A port number, if necessary. (Port 22 is the default.)
• The username and password. If the username has not been changed, the
default is admin. The password is the one you wrote down or configured
during initial configuration.
3
At the command prompt, enter
enable
, then enter the enable password that
you wrote down or configured during initial configuration:
SGOS> enable
Enable Password:
SGOS#
You are now in privileged mode.