Blue Coat SG810 series, Руководство по установке

Страница: 16 / 110

P/N 231-02941 SG810 Installation Guide page 16
Connecting the Cables
Connect the network cables, serial cable, and AC power cord.
Figure 1-10: Connect the Cables to the Back of the System
1
Plug the network cable into adapter 0. Plug a second cable into the other
adapter if desired.
The two full-duplex, auto-sensing Ethernet network adapters supporting
10/100/1000 Base-T connections are labeled 0 and 1.
2
Plug the serial cable into the serial connector, if necessary.
If you attach the serial cable, you can connect the system to a PC, serial
terminal, or stand-alone Serial Console box.
3
Plug the enclosed power cord into the power cord receptacle on the back of
the appliance.
Powering On the SG810
1
After you have connected the power cord to the rear of the system, plug the
other end of the power cord into a power receptacle.
2
Verify that the system has powered on successfully. See the four system states
described below and the corresponding states of the
Power LED .
Power LED
• No color : the SG810 is powered off or non-functional
• Solid Amber : the SG810 is powered on but unable to perform tasks (for
example, while booting up)
• Flashing Green to Amber : the SG810 is powered on but is not configured
Ethernet adapter
ports (Ports 0 and 1)
Serial port
AC Power