Blue Coat SG810 series, Руководство по установке

Страница: 11 / 110

P/N 231-02941 SG810 Installation Guide page 11
To attach the SG810 to the equipment mounting rack:
1
Position the SG810 into the equipment rack so that the ears of the brackets
align with the holes in the front of the rack.
2
Use equipment-rack screws to mount the SG810 to the equipment rack.
Figure 1-3 shows an SG810 flush-mounted on a Telco equipment rack.
Figure 1-3: SG810 Attached to a Telco Equipment Rack
Attaching the Cable Management Support
The cable management support routes network and serial cables to avoid
tangling.
Fasten the cable management support to the back of the system as follows:
1
Position the cable management support at the back of the system on the right;
secure it with a 6-32 x 1/4 Phillips head screw at the side.
Figure 1-4: Attach the Cable Management Support
When you attach cables to the system, run them through this clip to keep
them from tangling.
Use
equipment-rack
screws to attach to
the SG810 to the
rack
Attach the cable
management support with a
Phillips head screw