Blue Coat SG510 Series, Руководство по установке

Страница: 81 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 81
This is because the hostname no longer matches the hostname on the certificate.
You must create a new certificate and then edit the HTTPS-Console service to use
it.
For information about creating a new certificate and editing the HTTPS-Console
service, refer to the “Configuring HTTPS Termination” and “HTTPS Console
(Secure Console)” sections of the
Blue Coat ProxySG Configuration and Management
Guide Suite .
Resetting the SG510 to Factory Defaults
When the SG510 is powered on and has booted up, but an initial configuration
has not yet been performed, the Power LED flashes green and amber. If the Power
LED is solid green, the initial configuration has already been performed. If you
did not perform an initial configuration, but the Power LED is solid green, reset
the appliance to its factory defaults. Also reset the appliance if you cannot connect
to the Initial Configuration page through your browser. The initial configuration
Web page is accessible only to an appliance that has not been configured.
You can reset the SG510 to factory defaults using the Management Console or the
CLI.
To reset the SG510 to Factory Defaults
1
Access the SG510 Management Console.
https://
IP_Address
:8082
Where IP_Address is the IP address of the SG510.
2
Select
Maintenance>General
.