Blue Coat SG510 Series, Руководство по установке

Страница: 39 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 39
4.2.2.x—Configuring the SG510 Using a Direct Serial Port Connection:
Do the following procedure by reading the on-screen material and entering data
where necessary. In the procedure below, places that require you to enter data are
illustrated by example entries in bold text.
1
Power on and connect (a) a serial terminal or (b) a PC as described below (the
SG510
must be powered off):
Serial terminal : Connect the terminal’s serial cable to the SG510’s serial
console port; start the terminal and verify that it is set using the RS-232C
parameters defined in the following table.
RS-232C Parameters
PC : Connect the serial cable that came with the SG510 to a serial port on the
PC and to the SG510 ’ s serial console port; start the PC, open a terminal
emulator (such as HyperTerminal), and connect to the serial port to which
you attached the cable. Create and name a new connection (either a COM or
TCP/IP), and verify that the port is set using the parameters described in the
table above.
2
Power on the SG510 and wait for the system to finish booting.
Parameter Setting
Baud rate 9600 bps
Data bits 8
Parity none
Stop bits 1
Flow control none
Smooth-scroll disabled
Emulation VT 100