Blue Coat SG510 Series, Руководство по установке

Страница: 26 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 26
3
Press the
Left
or
Right
arrow buttons to position the cursor over the characters
you want to change; press the
Up
or
Down
arrow buttons to change them.
4
When you have all the characters of the parameter entered correctly, press the
Enter
button to save the changes and return to Configure mode.
5
Press the
Down
arrow button to move to the next parameter; press the
Enter
button to enter Edit mode.
6
Repeat Steps 3 through 5 for the Subnet mask, Gateway address, and DNS
address parameters. When the LCD reads, “Console password: Push to set,”
go to Step 7.
7
Press the
Enter
button to enter Edit mode (if necessary) and complete one of
the following steps:
•
To configure the password later (after you log in), write down the
auto-generated password and press the
Enter
button to return to
Configure mode.
•
To configure the password now, follow Steps 3 and 4.
8
Push the
Down
arrow button to move to the enable password parameter;
repeat Step 7 for the enable password.
The LCD displays “Enable password: Push to configure” when you are back
in Configuration mode. Do not push the
Enter
button again, or a new
auto-generated enable password will be created (if that happens, repeat
Step 7).
9
Push the
Down
arrow button to move to the secure serial port parameter.
Selecting
Yes
to secure the serial port means that you are challenged for the
administrative username/password when accessing the serial console and
challenged for the setup password when accessing the setup console.
To restrict access to the front panel, configure the front panel PIN from the
CLI after initial setup is complete (see
“Configuring a Front-Panel PIN” on
page 67).
10
Press the
Enter
button to enter Edit mode (if necessary) and follow Steps 3 and
4 to secure the serial port.
11
Press the
Menu
button to return to Status mode.