Blue Coat SG510 Series, Руководство по установке

Страница: 47 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 47
5.1.1.x—Configuring the SG510 Using a Direct Serial Port Connection:
Do the following procedure by reading the on-screen material and entering data
where necessary. In the procedure below, places that require you to enter data are
illustrated by example entries in bold text.
1
Power on and connect the serial terminal or PC as described below (the SG510
must be powered off):
Serial terminal : Connect the terminal’s serial cable to the SG510’s serial
console port; start the terminal and verify that it is set using the parameters
described below.
RS-232C Parameters
PC : Connect a serial cable to a serial port on the PC and to the SG510’s serial
console port; start the PC, open a terminal emulator (such as HyperTerminal),
and connect to the serial port to which you attached the cable. Create and
name a new connection (either a COM or TCP/IP), and verify that the port is
set using the parameters described in the preceding table.
If you have set flow control to none , and if you have smooth-scroll as an option
in your terminal settings, you can disable smooth-scroll in your terminal
settings to reduce the chance of losing output.
2
Power on the SG510 and wait for the system to finish booting.
Parameter Setting
Baud rate 9600 bps
Data bits 8
Parity none
Stop bits 1
Flow control none
Smooth-scroll disabled
Emulation VT 100