Blue Coat SG510 Series, Руководство по установке

Страница: 62 / 110

P/N 231-02833 Blue Coat SG510 Installation Guide page 62
Section F: Logging on to the SG510
After the SG510 is configured, the LCD will begin to cycle through and display
various messages, such as
CPU Utilization
and
Freshness
.
After you have completed the initial configuration and connected the SG510 to
the network, you must log on to the SG510 to fully configure the appliance. There
are two ways to do this.
• Use a browser to access the SG510 Management Console Web interface.
• Use a direct serial connection or an SSH Client to access the SG510
command-line interface (CLI).
Important: Blue Coat recommends that you set up a secure SSL connection
for greater security. For instructions, refer to
Volume 5:
Securing the ProxySG in the Blue Coat ProxySG Configuration
and Management Guide Suite .
Logging on to the SG510 Management Console
The Management Console is a graphical interface for configuring and managing
all aspects of the SG510. You can log on to the Management Console using a
browser.
To Log on to the Management Console Using a Browser:
1
Start the SG510.
2
Open a browser. The SG510 supports Microsoft® Internet Explorer 6.0,
Netscape® Communicator 7.2, and Firefox 1.0.
3
Enter the IP address configured during initial configuration, followed by the
port number
8082
. For example, enter:
https://10.25.36.47:8082
.
4
Click
Yes
in the Security Alert dialog; enter a username and password in the
Enter Network Password dialog that displays. If the username has not been
changed, the default is
admin
. The password is the one you wrote down or
configured during initial configuration.