Scan Setup
Click Scan button.
Use direction buttons to set camera left limit
and then click Left button.
Use direction buttons to set camera right
limit and then click Right button. Now the
scan setup process is complete.
8.3.2.2
Call PTZ Function
Call Preset: I
nput preset value and then click
to call a preset. Click
again to stop call.
Call Pattern: I
nput pattern value and then click
to call a pattern. Click
again to stop call.
Call Tour
Input tour value and then click
to call a tour. Click again
to
stop call.
Call Scan: I
nput Scan value and then click
to call a tour. Click again
to
stop call.
Rotate: C
lick
to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light function.
Note:
Preset, tour and pattern all need the value to be the control parameters. You can define it
as you require.
You need to refer to your camera user’s manual for Aux definition. In some cases, it can
be used for special process.
Aux:
Click
, system goes to the following
interface. The options here are defined by the
protocol. The aux number is corresponding to the
aux on-off button of the decoder.