8.3.2
PTZ Control
After completing all the setting please click save button.
Right click mouse (click “Fn” Button in the front panel or
click “Fn” key in the remote control). Please note you can
only go to the PTZ control interface when you are in 1-
window display mode.
Please note the commend name is grey once device does not
support this function.
The PTZ operation is only valid in one-window mode.
The PTZ setup is shown bellow.
Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern
aux function, light and wiper, rotation and etc. (functions will change according to
camera specifications).
Speed is to control PTZ movement speed. The value ranges from 1 to 8.The speed 8 is
faster than speed 1. You can use the remote control to click the small keyboard to set.
You can click
and
of the zoom, focus and iris to zoom in/out, definition and
brightness.
The PTZ rotation supports 8 directions. If you are using direction buttons on the front
panel, there are only four directions: up/down/left/right.
In the middle of the eight direction arrows, there is a 3D intelligent
positioning key. Please make sure your protocol supports this function
and you need to use mouse to control.
Click this key, system goes back to the single screen mode. Drag the mouse in the
screen to adjust section size. The dragged zone supports 4X to 16X speeds. It can
realize PTZ automatically. The smaller zone you dragged, the higher the speed.