724-746-5500 | blackbox.com
Page 54
724-746-5500 | blackbox.com
Chapter 3: The SmartPath AP (LWN602HA) Overview
Clip
3
Wrap the wire rope around a beam, clip the hook to the rope, and
then pull the rope downward until it is taut against the beam.
Pull downward
on the rope.
Beam
Locking
Device
Loop at Top of
Quad-Toggle
Quad-Toggle
Mounting Plate
SmartPath AP
Locking Device
4
Push the wire rope through the
side hole in the locking device
and then through the loop in the
quad-toggle.
5
Pass the wire rope upward through the
center hole in the locking device, and
continue pulling the rope to raise the
SmartPath AP to the height you want.
Mounting Plate
Quad Toggle
Clip
Locking
Device
Loop at Top of
Quad Toggle
Figure 3-20. Suspending the SmartPath AP.
6. Attach antennas to the antenna connectors on the SmartPath AP, connect one or two Ethernet cables to the network, and—
if not using PoE—connect the power cord to a power source.
Height Correction
If you accidentally pull too much wire rope through the locking device, raising the SmartPath AP too high, and you then need to
lower it, do the following: Take a tool, such as a screwdriver with a
1
⁄
8
" flat tip, and press it against the lip of the inner tube in the
opposite direction from the arrow on the outside of the locking device (see Figure 3-21). This releases its grip on the rope,
enabling you to pull out the rope the same way it was inserted. While maintaining pressure on the tube, adjust the rope until the
SmartPath AP is at the height you want. When you are satisfied, stop pressing against the tube so that it can regain its grip on
the rope.
Press against the lip of
the inner tube and hold.
While pushing the tube inward, pull the wire rope out.
Locking Device
Wire Rope
Screw Driver
Press against the lip
of the inner tube and
hold.
Locking Device
Wire Rope
Screwdriver
While pushing the tube inward, pull the rope out.
Figure 3-21. Releasing the wire rope from the locking device.