Operation Manual BioSmart PV-WM v.029.1|03.2021|en
Page 11 of 24
BioSmart PV-WM Reader
Operation Manual
2
Intended Usage
Operating Restrictions
The reader must be operated in accordance with the technical characteristics specified in
paragraph 1.2.
During the reader operation, exposure to vibration and shock loads exceeding the following values is
not allowed:
sinusoidal vibration in the frequency range 5 - 100 Hz with an amplitude of 30 m/s
2
;
impacts with an amplitude of 50 m/s
2
.
The reader may be operated in the ambient temperature range from minus 40 to plus 50
С
.
It’
s not allowed to install the reader in close proximity to heat sources and under the influence of direct
sunlight in order to avoid overheating of the reader.
The reader must be installed in accordance with the requirements of paragraph 2.3.
If the requirements of paragraph 2.3 are met (to ensure protection against moisture ingress into the
case), the reader may be operated in accordance with the degree of dust and moisture protection IP54 in
accordance with conditions (dustproof with protection against water falling on the housing in the form of
splashes). Impacts not falling under the IP54 protection degree are not permitted. Such unacceptable effects
are, in particular, a jet of water directed at the case or the device immersion in water.
If the requirements of paragraph 2.3 are not met, then the reader wo
n’
t be protected against dust
and moisture. In this case, use of the device in a dusty environment and the ingress of liquid on the case is
not allowed.
To ensure dust and moisture protection, violation of the integrity of the reader body (holes, chips,
cracks) is not allowed.
The reader may be used outdoors only if the following conditions are met:
the device is not in the open air, but covered with a canopy, roof or a special canopy for
BioSmart PV-WM;
all requirements of paragraph 2.3 have been met to ensure protection against dust and
moisture ingress.
The device can be operated at a relative humidity of not more than 70% at a temperature of 25
С
.
Moisture condensation is not allowed.
The device is not intended for use in aggressive and / or explosive environments.
Operation of the reader under conditions of ionizing (radiation) exposure is not allowed.
The device must be operated in conditions that exclude the influence of biological factors, such as
mold fungi, insects, animals.
Unqualified intervention in the reader design (namely, repair, improvement or any design changes)
by unauthorized persons is not allowed.
Preparing the Product for Use
1.
Security measures:
Only persons who have studied this operating manual and who have permission to work with
electrical installations up to 1000 V, who have the necessary knowledge in setting up network equipment
and OS Windows administration, are allowed to install and configure the terminal.
When servicing the product, observe the safety regulations applicable when working with energized
equipment.
It is forbidden to carry out installation, commissioning of the product during a thunderstorm, due to
the danger of electric shock during lightning discharges from interference on the communication line.
All work on installation and connection of devices must be carried out with the supply voltage
disconnected.
The product is not intended to use in flammable and explosive environments. Burning of the plastic
included in the product may release toxic combustion products
The safety of the operating personnel when working with the terminal is ensured through the use of
a safe low voltage supply.
After the reader has been exposed to low temperature or high humidity conditions, it must be taken
out of the package and kept in a dry room at a temperature of (20 ± 5) С
for at least 30 minutes before turning
it on.
