10
Cleaning your Astro Vacuum Blender
After fi nishing your blending session, you can clean the jug in various ways depending
on the ingredients you have used.
a. For thick or oily ingredients, use warm water into the jug with a few drops
detergent. Place jug into main unit. Press ON | OFF to activate the blender.
Press and hold the Pulse | Clean button and continue to press until jug looks
clean. Press ON | OFF to place the blender in Standby mode. Remove the jug
and rinse with clean water. Wipe the main unit with a wet or dry cloth.
b. Rinse the jug and lid directly under the tap and use a clean cloth to wipe up the
residual water.
***Always place jug in upright position when leaving to dry. Try not to have liquid
contacting the underside of the drive shaft.
Troubleshooting
PROBLEM
PROBABLE CAUSE
SOLUTION
When the jug is
on the base and
the control panel
does not light up.
Not plugged into electricity.
Electricity not turned on.
Replug cord into power
outlet. Check switch is
turned to ON position.
Ingredients are
diffi cult to blend
Too many solid ingredients
Add more liquid
Motor stops
suddenly during
operation.
Too much food may cause motor
to cut out.
Long durations of operating
or adding too much hard food
may trigger the protection
mechanism, causing the motor
to stop.
Voltage shortage. The power
voltage is unmatched or
insuffi cient for the blender.
Adding too much food takes
the working current beyond the
preset maximum.
Turn off. Remove some
of the food and power up
again.
Rest the blender for 20 –
45 minutes and restart it.
Make sure the power
supply is correct.
Rest the blender for 20 –
45 minutes and restart it.
Astro_Blender_Manual.indd 10
Astro_Blender_Manual.indd 10
22/6/18 2:46 pm
22/6/18 2:46 pm
