Command Reference
161
User’s Guide: Version 1.2
TFTP. The host at ipaddress can be a UNIX system or a PC and must
be configured as a TFTP host. The filename specifies the image to
load into flash ROM.
setup
setup
The setup command is used from the SNMP shell to start the
V!CAS Setup Tool. Setup Tool provides a menu oriented interface
to configuring the V!CAS and its major features, and administer-
ing/monitoring its operational state. For an introduction to using
Setup Tool see Using Setup Tool in Chapter 3. A description of all
menus is contained in Chapter 4, Setup Tool Menus. Informationon
configuring specific features can be found in Chapter 5, How do I
Configure ....
debug
debug
[
-t
] [
show
|
all
| [‹subs› [‹subs› …]]]
The debug command is available from the SNMP shell. The debug
command can be used to selectively display debugging informa-
tion originating from one or more of the V!CAS’ various subsys-
tems. Command line parameters are used as follows:
-t
Print a timestamp before each debugging message.
show
Show all possible subsystems that can be debugged.
all
Display debugging information for all subsystems.
‹subs›
One or more subsystems separated by whitespace can be
entered to display only debugging information from
these subsystems.
p
p
[
high
|
low
]
The p (priority) command sets the priority (high or low) of the
V!CAS’ SNMP shell with respect to other system processes.
The specified priority becomes effective for the current shell and all
sub-processes started from this shell. If no options are specified, the
current priority is displayed.
