Bilanciai D70E, Руководство по эксплуатации и обслуживанию

Страница: 69 / 88

1-69
D70E
10.2 Operation
The operating mode of the MPP is established during installation.
Operating modes are divided into two groups:
1) the user acts on the terminal, in particular on key , to save and
transfer weighing information;
2) the user acts on an external terminal (e.g. a PC) on the basis of the
methods envisaged by the type of software used.
In both operating modes, you can call up the consecutive number of the
weighing cycle on the display at the end of each memorisation.
The MPP identification code will be displayed at the end of a PWM operation
only if memorisation is activated by pressing the key.
The weighing terminal may provide warning messages informing operators
that it is impossible to correctly transfer or memorise information. In this
event, follow the on-screen instructions.
If MPP weighing is performed from an external terminal, you can activate a
print from the keypad.
10.3 Checking stored weight data
To check memorised weight information, press “2F” until “CODMPP”
appears.
The terminal will display the last CODMPP memorised. Press “EN” to select
this code or enter the code you need to consult.
Press "2F" to display the following memorised data in sequence:
net weight, tare (only if enabled), date and time associated to the MPP code
selected.
If the terminal is connected to a printer, press to print: displayed
weight, relative identification code, date and time.