OPERATION MANUAL
6.5 Working with accessories
6.5.1 Laminating on both sides
Required materials
■
Two laminating films (e.g. ProLam or AdLam)
■
A threading board (see p.15)
Advice
If you want to laminate a picture from both sides there is the pos-
sibility to install an additional electrical take-up unit on the front
side of the machine that winds up the silicone release paper of
the laminating film which is applied on the back
of the picture.
Sequence
1. Take off the front working table (8).
2. Adjust the rollers approx. 5 mm bigger than the thickness of
the threading board.
3. Equip the take-up unit (2) with a core
.
For this purpose push
the take-up unit towards the metal spring on the right side and
take it off to the top.
ATTENTION: If you look from the right side the barbed
hooks in the middle of the take-up unit must be adjusted
clockwise!
4. Load the laminating film onto the top supply shaft (1) so that
the film can be pulled toward the user from the underside of
the roll with the silicone release paper side facing to the bot-
tom.
5. Pull off the laminating film (incl. cover paper) from the sup-
ply shaft until it can be wrapped around the core from the bot-
tom. Fix the film (incl. cover paper) with an adhesive strip
on the core and wind up one rotation by hand. Adjust the
brakes on the cones so that the film can be unwound easily
but stays tight.
ATTENTION: Too much tension can lead to wrinkling!
6. Load the second roll of laminating film (incl. cover paper)
onto the bottom supply shaft (13) with the silicone release pa-
per side facing the bottom. Proceed analogously to the lami-
nating film on the top supply shaft (see point 5).
ATTENTION: Adjust the laminating film between the cones
in alignment with the laminating film on the top supply
shaft!
7. Cut the laminating film on the top supply shaft (1) widthwise.
ATTENTION: Just cut the film, not the cover paper!
8. Peel off the separated laminating film carefully from the cover
paper and pull it to the front until it lies loosely over the top
roller (6). Wind back the silicone release paper manually onto
the take-up unit (2).
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 27
