OPERATION MANUAL
6 Applications
6.1 Coating of substrates
Required materials
■
A double sided adhesive film (e.g. ArtMount S or AdMount)
■
A “ threading board” (a strip
of Forex, PVC or a similar mate-
rial (approx. 25 cm x width of the film, in the same thickness as
the substrate)
Sequence
1. Adjust the pressure according to the thickness of the substrate
(see p.12).
2. Load the double sided adhesive film onto the top supply shaft
(1) so that the film can be pulled toward the user from the
underside of the roll with the silicone release paper side facing
to the bottom.
3. Pull the double sided adhesive film to the front underneath the
pressure transmission shaft (4) and lay it loosely over the top
roller (6).
4. Push the film evenly in-between the rollers by using the
threading board so that the film is tight & wrinkle-free. Finally
feed-in the substrate. Due to economic reasons it is recom-
mended to coat several boards in succession.
ATTENTION: To avoid the adhesive film sticking to the
bottom roller, feed-in the boards without interspace!
Working boards
A working board is a board made of Forex, PVC, aluminium or a
similar material (no sharp edges) coated with a double sided ad-
hesive film.
ATTENTION: Do not remove the silicone paper!
The following explanations will show that working boards are
used in various applications. Therefore it is recommended to
have several working boards as basic equipment.
To make a working board please follow the explanations above.
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 14
