OPERATION MANUAL
6.4 Laminating and coating with double
sided adhesive
Required materials
■
A laminating film (e.g. ProLam or AdLam)
■
A threading board (see p.14)
■
A double sided adhesive (e.g. ArtMount S or AdMount)
Advice
It is possible to laminate as well as coat a picture from the re-
verse side with double sided adhesive in one working step.
Sequence
1. Equip the take-up unit (2) with a core
.
For this purpose push
the take-up unit towards the metal spring on the right side and
take it off to the top.
ATTENTION: If you look from the right side the barbed
hooks in the middle of the take-up unit must be adjusted
clockwise!
2. Load the laminating film onto the top supply shaft (1)
so that the film can be pulled toward the user from the
underside of the roll with the silicone release paper side facing
to the bottom.
3. Pull off the laminating film (incl. cover paper) from the sup-
ply shaft until it can be wrapped around the core from the bot-
tom. Fix the film (incl. cover paper) with an adhesive strip on
the core and wind up one rotation by hand. Adjust the brakes
on the cones so that the film can be unwound easily but stays
tight.
ATTENTION: Too much tension can lead to wrinkling!
4. Take-off the front working table (8).
5. Load the double sided adhesive film onto the bottom supply
shaft (13) with the adhesive side facing to the top.
ATTENTION: Adjust the double sided adhesive film be-
tween the cones according to the laminating film!
6. Cut the laminating film widthwise.
ATTENTION: Just cut the film, not the cover paper!
7. Peel off the separated laminating film carefully from the cover
paper and pull it to the front until it lies loosely over the top
roller (6). Wind back the silicone release paper manually
onto the take-up unit (2).
8. Pull the double sided adhesive film behind the switching axis to
the top (9) until it overlaps approx.10 cm of the laminating film.
Fix the back of the double sided adhesive film with little
pressure on the laminating film.
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 25
