OPERATION MANUAL
9. Cut the laminating film on the bottom supply shaft (13)
widthwise.
ATTENTION: Just cut the film, not the cover paper!
10. Peel off the separated laminating film from the cover paper
and pull it behind the switching axis (9) to the top until it over-
laps approx. 10 cm of the top laminating film. Wind back the
silicone release paper manually onto the bottom take-up unit.
Stick both laminating films together.
11. Push the laminating films evenly between the rollers by using
the threading board so that the films are tight without wrin-
kles. If necessary regulate the tension of the films with the aid
of the brakes on the cones.
12. Lower the top roller (6) until it touches the threading board.
Run the threading board through the rollers.
13. As soon as the threading board comes out the back of the
laminator
lower the top roller (6) and adjust the pressure
according to the thickness of the picture (see p.12).
14. Re-install the working table (8).
15. Run the picture through the rollers and start with the lamina-
tion process.
Picture 9
Take-up unit front side
Manual
Roll
Lam 120W;
Roll
Lam 140W;
Roll
Lam 160W 28
