Berthold Duo Xpert LB 478 MPLM, Руководство по эксплуатации

Страница: 100 / 136

12 Appendix LB 478 MPLM
100
56925-8BA2 Rev.00, 07/2019
Implementation on site
At this point, the steps to be carried out on site are listed. A detailed description
of the installation, electrical installation, etc. can be found in the respective oper-
ating instructions. Safety instructions must be observed!
Detector Positioning
In most cases, the detectors are installed by the customer. Prerequisite: Mounting
for the detectors is provided. Fix detectors to the mounting using appropriate
clamps. Positioning of the detectors according to specifications (see Table “Detec-
tors” in chapter 12.1.1). During commissioning, only a fine adjustment of the
detectors is usually necessary.
Evaluation Unit
The evaluation unit is usually preconfigured in the factory. Commissioning is doc-
umented by means of a commissioning protocol (see 12.2 Setup Protocol LB 478).
The following settings on the Master Control Unit must be checked:
1. Are all detectors incl. position applied? See Table “Detectors” in chapter 12.1.1
Fig. 71 Example Detector Configuration
2. Are all required interfaces created? See Table “Interfaces” in chapter 12.1.1
Fig. 72 Example Interface Densities