USER MANUAL
KYO100-KYO300
23
Arm/Disarm Single Partitions
This command will allow you to Arm/Disarm the Parti-
tions individually.
The Partition Identifier number
must always be en-
tered with 3 digits
(if necessary enter a
before
the number).
1.
Press
to access
Arm/Disarm Single Partitions
.
2.
Press
to Arm, or
to Disarm the Partition.
3.
Enter the Identifier number of the Partition.
The Partition will turn Arm/Disarm immediately, and
the system will go back to step
1.
Enable/Disable Teleservice
This command will allow you to Enable/Disable the
Teleservice facility
This is a toggle command:
if Teleservice is
ENABLED
, it will be
DISABLED
: the
executed command will be confirmed by an audible
feed back signal (low-pitched sound);
if Teleservice is
DISABLED
, it will be
ENABLED
: the
executed command will be confirmed by an audible
feed back signal (hgh-pitched sound).
Record/Play Memo
This command will allow you to Record/Play a memo:
Press
to access the Record/Play Memo phase:
Press
to record the message.
Press
to play message.
The end of recording/playback will be signalled by
an audible feed back signal (buzz). If you enter a
wrong Code, or a message has already been re-
corded but not played back, the system will emit
an audible feedback signal.
Reset Alarms
This command will allow you to clear Partition and/or
Control panel Alarms restore the system to standby,
depending on the Access level of the Code used via Tel-
ephone.
Enable/Disable Current User Code (ACTIVE)
This command will allow you to select/deselect the
AC-
TIVE
attribute for the entered User Code.
This is a toggle command:
if the entered User Code is already
ACTIVE
, it will
become
NOT
ACTIVE
(Disabled): the executed com-
mand will be confirmed by an audible feed back signal
(low-pitched sound);
if the entered User Code is
NOT
ACTIVE
(Disabled), it
will become
ACTIVE
(Enabled): the executed com-
mand will be confirmed by an audible feed back signal
(high-pitched sound).
This security feature will allow you to protect your
system against unauthorized access. If you Disable
a User Code via Telephone it cannot be used again
until it is Re-enabled via the User menu (refer to
“Programming PIN Codes” under “Accessing the User
Menu”).
APPENDIX
Default PINs (Factory default)
Table 7, on the following page, shows the default PINs of the User Codes for KYO 300 (100 User Codes for KYO 100):
the
No.
column shows the ID number of the User Code;
the
Description.
column (to be filled in by the Installer) is for the Code User’s name;
the
PIN.
column shows the default PIN of the corresponding User Code. The default PIN will be restored if the secret
Code PIN is duplicated (
Discovered
) by mistake (refer to “Programming PIN Codes” in the “OPERATING YOUR
SYSTEM FROM A KEYPAD” section).
Содержание KYO 100
Страница 1: ......
