USER MANUAL
KYO100-KYO300
21
OPERATING THE SYSTEM FROM A TELEPHONE
If your system has a
K3-VOX
Voice board (accessory
item), and your Installer has duly enabled the User Codes,
you will be able to control your system via any touch-
phone. KYO 300 manages
up to 64 Telephone Access
User Codes
(KYO 100 manages 16). Each Code can be
programmed to control specific functions and Partitions.
You can access the system over the phone:
after receiving a call from the Control panel;
after calling the Control panel and activating the An-
swering device facility.
Remote Access via ‘Dialler’ mode
If your installer has duly set up your Control panel, the
Dialler will send voice messages to the programmed tel-
ephone numbers when Alarm conditions are detected
(this Control panel manages up to 32 Telephone Num-
bers).
If you receive a Dialler call, you will be able to access
your system during the call by entering your
Access
Code
on the telephone keypad.
You can enter your
Access Code
while the message is
playing, or during the pauses between message an-
nouncements.
If the
Confirm successful calls
option is Enabled,
you must press the
key (Star) while the voice
message is still running, otherwise the Control panel
will consider the call “Unsuccessful”, and will carry
out the programmed Actions.
Remote Access via ‘Answer’ mode
If your installer has duly set up your Control panels to
answer incoming calls, you will be able to access your
system via the ‘Answering device’ facility.
The Answering function must be Enabled, otherwise,
you will be unable to access your system via remote
telephone. DO NOT use a telephone with a redial
button to Arm or Disarm your system, as this may
put your system security at risk.
If you are accessing your system via the ‘Answering de-
vice’ facility, two conditions are possible:
Teleservice Enabled
Teleservice Disabled
Teleservice Enabled
If the ‘Answer’ and ‘Teleservice’ facility are both Enabled,
your system will answer your call after the programmed
number of rings. It will emit a high-pitch audible signal
(beep), wait approximately 4 seconds then will play the
Answer message. At this point, you can enter your PIN
and send the required commands over the phone.
Teleservice Disabled
If the ‘Teleservice’ facility is Disabled, your system will
answer your call after the programmed number of rings.
It will emit a low-pitch audible signal then will play the
Answer message. At this point, you can enter your PIN
and send the required commands over the phone.
Entering the PIN code
You can enter your PIN while the message is playing, or
during the pauses between message announcements,
regardless of the Telephone Access mode (Dialler or An-
swer Mode).
Enter your Access Code then press
.
If your system recognizes your code, it will emit an audi-
ble feed back signal (short high-pitched beep), and will
accept commands.
If your system DOES NOT recognize your code, it will
emit an audible error signal (buzz).
The system will end the call automatically, if no valid
code is entered within 30 seconds (at default). This in-
terval can be customized from 1 to 254 seconds.
If necessary, press
to delete wrong digits and restart.
Entering Commands
Once your PIN has been recognized, you can enter the
Command Codes. If you enter a wrong Code, the sys-
tem will emit an audible error signal (buzz)
If you enter a valid Code, the system will emit an audible
confirmation signal (beep).
The system will end the call automatically, if no Key
is pressed within 2 minutes.
Содержание KYO 100
Страница 1: ......
