Bentel Security KYO 100, Руководство пользователя

Страница: 16 / 24

USER MANUAL 16
Š Š
Several Users can access the Programming phase at
the same time from different Keypads. Invalid opera-
tions will be signalled by an audible error signal.
ALISON/L32P LED Keypads will accept the following
commands:
Reset Alarms
Enable/Disable auto-arm
Enable/Disable Teleservice
Overtime request
Teleservice request
Enable/Disable Buzzer
Test Siren
Enable/Disable Answering device
Clear Call Queue
Your Installer has programmed your Control panel
with your requirements in mind, therefore, some of
the options mentioned may not be available.
Only the first Code (ID no. 001 — PIN 0001 ) is Active at
default.
The operations will affect ONLY the Zones and Par-
titions common to the User and Keypad concerned,
as per the configuration set up during the Program-
ming phase.
The following section describes the commands which
can be implemented.
Reset Alarms
To Reset Alarms (refer to page 9), proceed as follows.
1 . Access the Programming phase (see above).
2 . Press to Reset Alarms.
Enable/Disable auto-arm
To toggle the status of the Partition Schedulers, common
to the User and Keypad concerned (refer to page 11),
proceed as follows.
1 . Access the Programming phase (see above).
2 . Press .
Enable/Disable Teleservice
To Enable/Disable the Teleservice facility (refer to page
11), proceed as follows.
1 . Access the Programming phase .
2 . Press .
LED 2 on the Keypad will turn ON/OFF to indicate re-
spectively the Enabled/Disabled status of the Teleserv-
ice facility.
Overtime Request
To make ‘Overtime Requests’ (refer to page 12), proceed
as follows.
1 . Access the Programming phase .
The command will be implemented immediately..
Teleservice Request
To make ‘Teleservice Requests’ (refer to page 11), proceed
as follows.
1 . Access the Programming phase .
2 . Press .
The command will be implemented immediately.
Enable/Disable Buzzer
To Enable/Disable the Buzzer (refer to page 15), proceed as
follows.
1 . Access the Programming phase .
2 . Press .
LED 5 on the Keypad will turn ON/OFF to indicate re-
spectively the Enabled/Disabled status of the buzzer.
Test Siren
To activate Output 1 for 3 seconds (refer to page 15), pro-
ceed as follows.
1 .Access the Programming phase .
2 . Press .
The command will be implemented immediately.
Enable/Disable Answering device function
To Enable/Disable the Answering device function (refer to
page 11), proceed as follows.
1 . Access the Programming phase .
2 . Press .
LED 9 on the Keypad will turn ON/OFF to indicate re-
spectively the Enabled/Disabled status of the Answer-
ing device function.
Clear Call Queue
To Clear the Call Queue (refer to page 12), proceed as fol-
lows.
1 . Access the Programming phase .
2 . Press .
The command will be implemented immediately.
Keys and are not used for User Menu op-
erations