Bentel Security KYO 100, Руководство пользователя

Страница: 20 / 24

USER MANUAL 20
Š Š
To restore the setting (reset the Arm Mode that was
active before the SAT Key was inserted) — push
the SAT Key into the ECLIPSE Reader until the 3
LEDs start to blink slowly, the previous setting will
be restored when the Key is removed.
Arm/Disarm Patrol
Digital Keys/Cards with this attribute can Arm/Disarm
the system during the programmed Patrol Time.
The Wireless Key
If your system is equipped with a Vector/RX Wireless
Receiver, it will be possible to control all the main func-
tions from remote locations by means of Wireless Keys
(see Figure 4).
This section describes the functions that can be
controlled by Wireless Keys.
The operations performed by Wireless Keys will not
be confirmed by any type of feed back signal (audi-
ble or visual), unless done in the vicinity of a Reader
or a Keypad, or a device that has been especially
set up to provide feed back signals.
Global Mode
Press the button until the LED turns ON (see Fig. 5),
to Arm all the Partitions of the Wireless Key in use.
Stay Mode
Press the button until the LED turns ON (see Fig. 5),
to Arm all the Partitions of the Wireless Key in use in
Stay Mode.
Disarm
Press the button until the LED turns ON (see Fig. 5),
to Disarm all the Partitions of the Wireless Key in use.
Other functions
Press the key until the LED turns ON (see Fig. 5),
to activate the special functions programmed for the Wire-
less Key in use.
Low Battery
If any of the Wireless Key batteries starts to run low, the
G
LED on the Keypads will Turn ON.
All the system Trouble conditions are signalled by
the
G
LED. Therefore, if this LED turns ON, you
must access the View Trouble Mode for details.
The Low Wireless Battery condition will be signalled in
View Trouble Mode by the [ Low_battery_WLS ] mes-
sage (refer to "View Trouble Mode" under "Basic Com-
mands" in the "OPERATING YOUR SYSTEM FROM A
KEYPAD" section).
The Event Logger (
refer to the IDENT field of the event
TYPE [ Battery_low_____ ]) will provide the details of
the Wireless key that has triggered the Low battery con-
dition (refer to "Event Logger" under "Accessing the User
menu" in the “OPERATING YOUR SYSTEM FROM A
Fig. 5 - Wireless key
KEYPAD" section).
Call your installer and have the battery replaced.