Bentel Security KYO 100, Руководство пользователя

Страница: 14 / 24

USER MANUAL 14
Š Š
<&(/?
/?AAAAAA
4. Enter the new PIN (4 to 6 digits) — * will replace X as
you enter the new digits.
5. Press the
E
key, the display will show the following
message:
2&(/?
/?AABBBB
In the example above, two digits have been entered.
6. Enter the new PIN again, the press the
E
key to con-
firm and go back to step 1.
If necessary, press the
e
: key to abandon the proce-
dure and go back to step 1.
You cannot assign the default PIN of one code to
another Code (refer to Table 9).
If you attempt to assign the default PIN of one Code to
another Code, the display will show the following mes-
sage:
2& ( /?
You cannot assign a PIN that already exists on the
system.
If you attempt to assign a PIN that has already been
assigned to another Code, the display will show the fol-
lowing message:
2& ( /?
!)& /?
This message indicates that the PIN already exists on
the system, therefore, the Control panel will consider the
Code to be “Discovered” and, for security reasons, will
automatically restore the default PIN of the Code in ques-
tion.
If a User attempts to access the system using a “Dis-
covered” PIN, the display will show the following mes-
sage:
!
“Discovered” PINs (at default) must be repro-
grammed (refer to Table 9).
“Discovered” PINs will be signalled by:
the
G
LED (ON) on the Keypad
the Discovered PIN! message in View Trouble mode
the Event details in the Logger
TYPE = Discovered PIN
IDENT. = the Keypad used
TIME = Time and Date of the Event
The Trouble status will clear as soon as a New PIN (other
than the default PIN) is assigned to the Code with “Dis-
covered” PIN status.
Memo
This command will allow you to record and play voice
memos.
C:
2:
This option must be duly programmed by the Installer,
otherwise it will not be available on the Keypad.
To record voice memos
1. Press
E
to start recording.
C:
........
The dashes on the second line of the display will indi-
cate the elapsing timeout.
The Green
M
LED on the Keypad will turn ON to indi-
cate that there is a new memo.
To play voice memos
1. Press
C
or
D
to display Play message :
C:
/':
2. Press
E
to play the voice memo:
C:
........
The dashes on the second line of the display will indi-
cate the elapsing timeout.
The Green
M
LED on the Keypad will turn OFF to indi-
cate that there are no unplayed memos.
You cannot record a new message until the current
message has been played.
Disable buzzer
If the Keypad buzzer is Enabled, it will signal the Entry
and Exit Times , and Violation on Chime zones . This
command will allow you to Disable these audible sig-
nals.
When you select this command the display will show
the following message:
+;;3<<!
3<<!'$
Press
O
to Enable, or
o
to Disable the buzzer.
Press the
E
key to step back to the User menu.