BENSON MH300, Инструкция пользователя, Страница: 6 / 26

1.5 Warranty
The heater is supplied with a 2 year warranty made
up as follows; first year covering parts and labour,
and second year covering parts only. In addition to
this there is also a 10 year time related warranty on
the combustion chamber/heat exchanger. The
warranty commences from the date of dispatch from
the manufacturer, and is subject to the terms
detailed within the Benson Heating 'conditions of
business'.
Note (i)
The warranty may be invalidated if –
a) The warranty registration/commissioning card
has not been completed and returned to Benson
Heating
b) The installation is not in accordance with the
general requirements of this manual
c) The flue arrangement and air supply for the
heater are not in accordance with the
manufacturers recommendations, codes of practice,
or similar standards
d) Air flow through the heater is not in accordance
with the manufacturers technical specifications
e) Internal wiring on the heater has been tampered
with or unauthorised service/repairs undertaken
f) The main electrical supply input to the heater has
been interrupted during the heating mode
g) The heater has been subject to and affected by
the ingress of water in any form
h) The heater is not operated at the rating(s) laid
down in the manufacturers technical specifications
i) The heater has not been operated or used within
the normal scope of its intended application
j) The manufacturer's recommended minimum
service requirements have not been complied with
Note (ii)
All warranty claims must contain the following
information to enable processing to take place;
(1) Heater model
(2) Heater serial number
(3) Order reference/date of order, together with full
installation details (name and address)
(4) Details or symptoms of fault
Faulty parts must be returned to the Knighton
Spares Department, the address of which is
provided on the rear cover of this manual. Any such
parts will undergo inspection to verify the claim.
Replacement parts supplied prior to this may be
charged, and a credit supplied upon subsequent
validation of the warranty claim.
Consumable items are specifically not included
within the scope of the warranty.
Note (iii)
Notification is required immediately a fault is
suspected.
The manufacturer will not accept responsibility
for any additional damage that has been
caused, expense incurred, or consequential
loss resulting from any failure of the heater(s).
2.0 Location/Positioning
Warning
All of the basic criteria must be satisfied prior to
commencing installation and commissioning,
additionally, the Heater must be positioned and
installed so as to comply with all the relevant
standards and guide lines (see section 9.0), as well
as meeting national and local fire regulations and
insurance criteria, especially if it is proposed that
the heater is to be installed within a special risk
area (e.g. proximity to where petrol engined
vehicles are stored or parked, where cellulose
spraying takes place, where woodworking
machinery is operated, etc,).
Indirect fired heaters must not be located in
hazardous areas, however, it is permissible for the
heater to supply air to such areas.
The heater must not be installed within an
environment where there is a high concentration of
chlorides, fluorides, salts, or other aggressive or
volatile chemicals/compounds.