Bennett CNG Spec. 100 Series Operators Manual
Programming
29
PLC ADDRESS (MODBUS SECONDARY I D)
This option is used to enter the PLC Modbus Secondary ID (if applicable). The PLC Modbus Secondary ID address range is 0 through 247.
The default setting is set at 0.
TO ENTER THE PLC ADDRESS IN MENU CODE 22, FOLLOW THIS PROCEDURE:
1.
Press the number
2
and
2
, then the [
MODE]
button on the keypad. The PPM display
shows the dispenser in Menu Code 22. If the dispenser has not been programmed
since it came from the factory, the default address appears in the main display as
shown in
Figure 4.37.
2.
To change the setting, use the numeric keypad to enter a new address.
Note
: If an
error is made, press the correct number. The new number replaces the error.
3.
Press [
ENTER
] to save the new setting and to cycle to the next available option. If
programming is complete press, [
CANCEL
] to exit this menu option.
4.
Press the [
CANCEL
] button again to exit mode 22
PLC LOWEST ADDRESS
This option is used to enter the lowest PLC address sent by the PLC (if applicable). The dispenser needs to know the lowest address sent
by the PLC so the dispenser can verify the address and map the addresses to the data correctly. The lowest address could be 0 or 1. The
default setting is set at 0. However, some PLC’s have a lowest address of 1.
TO ENTER THE PLC ADDRESS IN MENU CODE 22, FOLLOW THIS PROCEDURE:
1.
Press the number
2
and
2
, then the [
MODE]
button on the keypad. The PPM display
shows the dispenser in Menu Code 22. If the dispenser has not been programmed
since it came from the factory, the default address appears in the main display as
shown in
Figure 4.38.
2.
To change the setting, use the numeric keypad to enter a new address.
Note
: If an
error is made, press the correct number. The new number replaces the error.
3.
Press [
ENTER
] to save the new setting and to cycle to the next option.
4.
If programming is complete press, [
CANCEL
] to exit this Menu Code.
Sale $
plc
GGE
add 0
code
- 22
FIGURE 4.37 PLC MODBUS SECONDARY ID
Sale $
plclo
GGE
add 0
code
- 22
FIGURE 4.38 PLC MODBUS SECONDARY ID
Содержание CNG Spec. 100 Series
