Bennett CNG Spec. 100 Series, Руководство оператора

Страница: 22 / 58

Bennett CNG Spec. 100 Series Operators Manual Programming
16
TO TEST THE ACCESS C ODE, FOLLOW THIS PRO CEDURE:
1. Put the dispenser in the
OPERATE
mode by unplugging the Manager’s Keypad from
the dispenser.
2. Re-enter the
ATTENDANT
mode by plugging the keyboard back in the product
select/auxiliary backlight board.
3. Press [ ENTER ] for Side 1.
4. Press the 3 button and then the [ MODE ] button on the keypad.
5. Press the new four-digit access number. Four dashes appear in the mass display.
6. Press the [ ENTER] button. If access is gained, the four dashes disappear and the main
price display appears as in Figure 4.1 shown on the previous page. Note : If the dashes
do not appear, an error was made. Repeat Steps 1 through 4.
NOTE: If you make a mistake or lose your new passcode, the pump main memory will have to be zeroed to regain access
to totals information and programming menus. Please call your Bennett authorized service technician to zero the
dispensers main menu and return the passcode to 2218. This is NOT a warranty paid service call.
MENU CODE 4 - HOW TO PROGRAM PRICE PER MASS
NOTE: Access code (Menu Code 3) must be entered into the pump and the PPM display must indicate dashes before this
mode may be entered.
NOTE: The Price Per Mass reflected in these figures represent a setup with 2 Tier Pricing.
TO PROGRAM PRICE PER MASS DATA, FOLLOW THIS PROCEDURE:
1. Press the 4 button and then the [ MODE ] button on the keypad. See Figure 4.5 for
the location of Product 1 Price on the CPU side of the dispenser. The main display
shows that Product 1, Tier 1 in Code 4 is active.
2. Use the 0 through 9 buttons on the keypad to enter the price for Product 1, Tier 1.
3. When the first digit of the new price is entered. The main display will show zeros and
indicates the new digit in the right most digit. The PPM display continues to flash the
old price as shown in Figure 4.6. When the correct price appears in main display,
press the [
ENTER ] button. The PPM display now contains the new price as shown in
Figure 4.7. Note: If an error is made, press the 0 through 9 buttons on the keypad
until the correct price appears in the PPM display.
4. Repeat steps 2 and 3 for the remaining prices to be set. The dispenser only displays
the number of hoses selected in Menu Code 7.
5. Press the [ CANCEL ] button to exit this Menu Code.
FIGURE 4.4 – NEW ACCESS CODE ENTRY
Sale $
pass
GGE 0000
code -- 3
FIGURE 4.5 – PROGRAM PPM
Sale $
P 11.4
GGE
00
0.000
Flashing
Sale $
P 11.4
GGE 1.111
0.000 -- 1
Flashing
FIGURE 4.7 – NEW PRODUCT PRICE
Sale $
P 12.4
GGE 0.000
1.111
Flashing
FIGURE 4.6 – OLD PRODUCT PRICE