Benelli 2009 TREK1130, Руководство по ремонту

Страница: 235 / 582

FRONT FORK
4 73
CHAS
Insert:
• the washer
• the pumping unit fixing screw
Fasten using an 8 mm Allen spanner:
Assemble the fork in vice by fixing it from the wheel
holder foot.
Lower the fork sleeve on to the fork shank.
K
L
ATTENTION
ATTENTION to the introduction direction of the
spring. The tighter part must face upwards.
ATTENTION
A lower or higher air volume, or a type of oil
different to that prescribed, may change the
behaviour of the fork in its every phase.
8
8
ee
Completely lift the fork sleeve.
g
f
In a graduated beaker prepare the quantity of oil to
pour into the stem.
Pour inside the fork sleeve approximately
2/3 of the required oil, therefore pump a few times
to eliminate the air.
Proceed until the required amount is poured.
Lower the fork sleeve on to the fork shank to the
stroke of the dust seal on the wheel holder foot.
Wait a few minutes and check the air volume and
eventually restore the level.
h: 130 mm.
eh
i
L
K
50 N m - 5.09 Kgf•m
T.
R.
j
k
l
M
h
M
Insert inside the fork sleeve:
• the spring pointer
• the lower spring guide bush
• the spacer
• the upper spring guide bush
• the fork spring
• the spring pointer
N
O
P
Q
R
S
Q
P
O
N
S
R
9
9
5
2
A
4
3
NEW
TYPE:
SAE 7.5
Quantity:
710 cc
AREXONS SYSTEM 52A43
MEDIUM THREAD BRAKES
52A43