Benelli 2009 TREK1130, Руководство по ремонту

Страница: 139 / 582

ELECTRIC PLANT/BATTERY CHARGE AND CONTROL
3 82
CHK
ADJ
Charging method with a battery charger of variable current (voltage) type
By rotating the adjusting
washer of the charge
voltage, set the charge
voltage on 20 ~ 24 V.
Keep amperage under
control for 3 ~ 5 minutes
to check if the standard
charge current is reached.
If the current does not
exceed the standard
charge current once 5
minutes have passed,
replace the battery.
If charging requires more than 5 hours, we recommend checking the charge current after 5 hours.
If amperage variations occur, adjust the voltage again to obtain the standard charge current.
Measure the battery voltage with open circuit after having left the battery unused for over 30 minutes.
12.8 V or above Charging is completed
12.7 V or below Requires charging.
Below 12.0 V Replace the battery.
Measure the voltage with open
circuit before charging.
Connect a battery charger and
an ammeter to the battery
and start charging.
Check that the current is higher than
the standard value of the charge
current shown on the battery.
Adjust the voltage so that the
current is at standard charge level.
Set the time according to
the charge time suitable
for voltage with open circuit.
See the instructions with
the battery.
NOTE:
Measure the voltage 30 minutes after
having switched off the equipment.
NOTE:
Set the charging voltage on 16~17 V.
(By setting it on a lower value, the
charge would be insufficient.
Whereas, if it is set on a value too
high, the battery would be
overcharged).
NO
NO
SI
SI
A
Battery charger
Ammeter