BendPak RS7580H603, Инструкция по установке и эксплуатации

Страница: 3 / 48

3
SECTION 1
Our Screw Compressor units are intended to provide
compressed air to power pneumatic tools, operate spray
equipment and supply air for pneumatic valves and
actuators. A small amount of oil carryover is present in the
compressed air stream. The compressed air has a final oil
level of < 3ppm. Applications requiring higher levels of air
free of oil vapor should have the appropriate filter installed.
The Screw compressor units are to be mounted per the
instructions provided on a solid floor. Any other use of these
units will void the warranty and the manufacturer will not be
responsible for problems or damages resulting from such
misuse.
SAFETY GUIDELINES
This manual contains information that is very important
to know and understand. This information is provided for
SAFETY and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information, observe the following
symbols.
Watch for this symbol: It Means: Immediate hazards which
will result in severe personal injury or death.
Watch for this symbol: It Means: Hazards or unsafe practices
which could result in severe personal injury or death.
Watch for this symbol: It Means: Hazards or unsafe
practices which may result in minor personal injury or
product or property damage.
INTRODUCTION
1. Carefully remove the crating and packing materials.
Be careful when cutting steel banding material as items may
become loose and fall causing personal harm or injury.
2. Check the voltage, phase and proper amperage
requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician only.
3. Confirm voltage before connecting power to your machine
or serious damage to the motor/electronics will result.
BREATHABLE AIR WARNING
This compressor/pump is NOT equipped and should NOT
be used “as is” to supply breathing quality air. For any
application of air for human consumption, you must fit
the air compressor/pump with suitable in-line safety and
alarm equipment. This additional equipment is neces-
sary to properly filter and purify the air to meet minimal
specifications for Grade D breathing as described
in Compressed Gas Association Commodity
Specification G 7.1 - 1966,
and
OSHA 29 CFR 1910.
134.
DISCLAIMER OF WARRANTIES
In the event the compressor is used for the purpose of
breathing air application and proper in-line safety and
alarm equipment is not simultaneously used, existing
warranties are void, and the company disclaims any
liability whatsoever for any loss, personal injury or damage!
UNPACKING
After unpacking the unit, inspect carefully for any damage
that may have occurred during transit. Make sure to tighten
fittings, bolts, etc., before putting unit into service.
Do not operate unit if damaged during shipping, handling
or use. Damage may result in bursting and cause injury or
property damage.
Failure to follow danger, warning, and caution instructions
may lead to serious personal injury or death to operator
or bystander or damage to property. Do not operate this
machine until you read and understand all the dangers,
warnings and cautions in this manual.
For additional copies or further information, contact:
BendPak Inc. / Ranger Products
1645 Lemonwood Dr.,
Santa Paula, CA. 93060
1-805-933-9970
www.bendpak.com
Tel: (805) 933-9970
Toll Free: (800) 253-2363
Support: (800) 253-2363 Ext. 196
Customer Service Fax: (805) 933-1128
To order parts: (800) 253-2363 Ext. 191