BendPak RS7580H603, Инструкция по установке и эксплуатации

Страница: 29 / 48

29
3. Remove and replace the Valve Body Top Gasket.
Remove the Valve. (See Fig. 12.14)
4. Inspect the white seal on the Valve for damage or
cracks. Replace if damaged. (See Fig. 12.15)
5. Lubricate Valve and Valve Spring with high
temperature grease. (See Fig. 12.16)
6. Install new Gasket. Installation is reverse of the above
procedures.
OIL CHANGE PROCEDURE
ATTENTION:
Replace the Oil more frequently when the
dust level and the operating temperature are
high, in severe operating environments
or severe demand applications.
1. Connect a drain hose up to the Drain Ball Valve.
2. Open the Oil Fill Plug.
3. Open the Drain Ball Valve and drain used oil into an
approved container and dispose of in accordance with
local regulations. (See Fig. 12.17 )
4. Close Drain Ball Valve.
5. Use a clean funnel, fill the Oil Separation tank with
PowerCool Synthetic Air Compressor Lubricant.
6. Install and tighten the Oil Fill Plug.
7. The oil level must be above the upper red line after
the compressor is off has been stopped for thirty minutes.
The oil level when the compressor is running must be
between the upper and lower red line indicated on the Oil
Level Site glass. (See Fig. 12.18 -12.19 )
Oil Tank
Drain Valve
Oil Fill Plug
Oil Level
Site Glass
Fig. 12.18
Fig. 12.14
Fig. 12.17
Valve
Gasket
Fig. 12.15
Inspect Seal Areas
Inspect and
Lube Spring
Fig. 12.16