BendPak RS7580H603, Инструкция по установке и эксплуатации

Страница: 12 / 48

12
3. Fill with PowerCool Synthetic Air Compressor
Lubricant if necessary and inspect the O-Ring on the Oil
Fill Plug before tightening.
TRANSMISSION INSPECTION:
Belt Inspection.
1. Remove the Access panel on the right side Drive Belt
Side of the Compressor.
2. Check that all drive belts are in the pulley grooves.
Adjust the tension of belts through the adjusting Bolt on
motor. (See Fig. 8.6)
(See Belt maintenance on page 28 for Belt adjustment
details.)
STOP VALVE INSPECTION
Check if the stop valve is open.
SECTION 9
DAILY OPERATION
EMERGENCY STOP
1. To immediately stop the Compressor press the
Emergency Stop Button to cut off the power supply of the
controller and contactor power. (See Fig. 9.1)
2. To Reset Emergency Stop; Twist Emergency Stop
Button clockwise, The Emergency Stop Button will pop
back out. The Compressor cannot be restarted until the
failure has been cleared and the Restart Delay time (90
seconds) has expired.
3. The Compressor cannot be restarted until the failure
has been cleared and the Restart Delay time (90 seconds
default) has expired.
DAILY STARTUP PROCEDURE:
Before start up:
a) Check the operating button to see if it is in normal
condition.
b) Make sure there are no abnormal noise vibration or
oil leakage.
c) Check the instruments of pressure gauge, oil
thermometer, ammeter, indicator light, etc are in
Fig. 8.6
DO NOT OVER FILL. OVER FILLING CAN CAUSE
A HIGH LEVEL OF OIL IN THE COMPRESSED AIR.
DO NOT UNDER FILL. UNDER FILLING CAN CAUSE
OVER HEATING AND DAMAGE.
Minimum Oil Level
when stopped
and cold
Minimum Oil Level
while running
Fig. 8.5
IN THE EVENT OF ANY TROUBLE OR
OPERATION PROBLEM NOT DETECTED
AND TERMINATED BY THE CONTROL SOFTWARE.
THE COMPRESSOR CAN BE SHUT DOWN BY
PRESSING THE EMERGENCY STOP BUTTON.
Emergency Stop
Button
Fig. 9.1