BendPak RS7580H603, Инструкция по установке и эксплуатации

Страница: 20 / 48

20
e. HISTORY FAULT –
DISPLAYS “FAULT HISTORY”
f. PRODUCTION DATE, NUM
i. PROD DATE: 2009:xx:xx
ii. SERIAL NUMBER: xxxxxxxx
DISPLAYS THE PRODUCTION DATE AND SERIAL NUMBER.
These hour counters can be reset under FACTORY PARAMETERS.
g. THIS FAULT-
DISPLAYS “CURRENT FAULT STATUS”
These faults can be cleared by fixing fault.
2) CALENDAR- ( DISPLAYS /MODIFY CURRENT DATE AND TIME, NO PASSWORD REQUIRED)
DATE & TIME
2009-11-17
W-2
00: 00: 00
H M SEC
Can be reset from this screen
3) CUSTOMER PARAMETER (Modifies Values)( Password Required)
a. SET P.T.
i. LOADING – xx.xx Mpa
Pressure at which Compressor will switch to LOADED STATE
(To build pressure). (NOT APPLICABLE)
ii. UNLOADING – xx.xx Mpa
Pressure at which Compressor will switch to Unload State.
(Not Build Pressure) (NOT APPLICABLE)
(NOTE: Maximum and minimum pressure is set using the PRESSURE SWITCH Mounted behind the
Power Control Box.)
iii. FAN START- x °C
The Oil temperature at which fan will turn on.
iv. FAN STOP - x °C
The Oil temperature at which fan will turn off.