BendPak RS7580H603, Инструкция по установке и эксплуатации

Страница: 11 / 48

11
INSPECTION OF THE SCREW AIR END
1. Rotate the Pulley on the Screw Air End by hand a cou-
ple of complete rotations counterclockwise to ensure the
Air End is not locked and is pre-lubricated. (See Fig. 8.1)
IF COMPRESSOR HAS NOT BEEN IN USE
FOR MORE THAN TWO MONTHS OR STORED
FOR A LONG PERIOD OF TIME, PERFORM
THE FOLLOWING STEPS:
Refer to Maintenance, Section 12 for details on Intake
Valve Assembly.
1. Remove the Air Intake Filter Housing and Filter.
2. Open the Intake Valve by pressing down gently on
top of the Intake Valve to open and hold open.
(See Fig. 8.2)
3. Then pour .5 quart (.5 litre) of lubricating oil into
Air End through the Intake Valve.
4. Rotate the Pulley on the Screw Air End by hand a
couple of complete rotations counterclockwise to ensure
the Air End is not locked and lubricated properly.
(See Fig. 8.1)
5. Make sure all oil enters Air End.
6. Make sure Intake Valve closes when released.
OIL LEVEL INSPECTION
1. Remove the Access panel on the Oil Separator Side
of the Compressor. (See Fig. 8.3)
2. The oil level must be above the upper red line after
the compressor is off has been stopped for thirty minutes
The oil level when the compressor is running must be
between the upper and lower red line indicated on the Oil
Level Site glass. (See Fig. 8.4 & 8.5)
Fig. 8.1
Fig. 8.2
LOCK OUT SOURCE AND RELIEVE PRESSURE
BEFORE SERVICING.
Fig. 8.3
Oil Fill Plug
Oil Level
Site Glass
Fig. 8.4