Bender UNIMET 1000ST, Руководство по эксплуатации, Страница: 51 / 100

Testing and measuring
51 TGH1256en/10.2005
5. Testing and measuring
5.1 Test concept
The integrated type and device catalogue provides the basis for time-efficient and cost-
effective testing with UNIMET® 1100ST.
Classification
The UNIMET® 1100ST can be used to carry out tests in accordance with the standards
indicated in “System description” on page 11. For new devices, which have not yet been
created in the type catalogue, the test steps required and the associated limiting values are
determined in dialogue between the test engineer and UNIMET® 1100ST. This classification
is then saved as a test procedure for a specific device in the type catalogue, from where it
can be called up for all other devices of this type.
Type catalogue
The test procedures for devices already classified are saved in this catalogue under type
designations (e.g. AFX infusion pump). The first time a new device is tested whose type
already exists in the type catalogue, only the type designation needs to be called.
Once the test has been completed successfully, the DUT is saved in the device catalogue
under the ID number. This saves an enormous amount of time where new acquisitions are
concerned. A further advantage is that all devices of the same type are tested under identical
conditions.
Device catalogue
Measurement data for individual devices is saved in the device catalogue under the ID
number. In the event of periodic testing, only the ID no. needs to be selected. Connect DUT
– Test – Done. This saves an enormous amount of time where periodic tests are concerned.
In the event of periodic testing, this means that a device will always be tested in accordance
with the same test procedure.
Single test
Test steps can be called up in the form of single tests and repeated as often as required. If,
for example, a limiting value is not observed during a classified test sequence, the test step
concerned can be examined in more detail using a single test.