Bender TM800, Руководство пользователя, Страница: 36 / 92

Installation and connection
36 TM800_D00165_00_M_XXEN/06.2015
Explanatory note to the digital inputs (*)
Alarm messages from digital inputs on TM/MK800 are always displayed on the device itself regard-
less of whether an individual message has been programmed or not (Exception:
channel is deactivated).
An entry into the alarm address table is not required.

If no individual message is programmed, the standard text will be displayed.

An alarm message can also be programmed to be displayed without text/LED/buzzer ( silent
message ).

Note: Flashing alarm messages are not allowed!
In principle, all alarm messages are stored in the history memory (Exception: channel is deactivated):

If no individual message is programmed, the standard text will be displayed resp. will be stored
in the history memory.

If the message has been programmed without a text (silent message), its source (DigIn resp.
address and channel No.) will be stored in the history memory (no individual text possible!).

Test messages are only stored in the history memory of the device that triggered the message.
Transmission via BMS bus:

All alarm messages are actively sent (i.e. as a new message) via the external or internal BMS.
Operating messages are actively sent via the external BMS bus and are not stored in the history
memory.

Note: Flashing messages must be avoided, where possible, and on no account be sent via the
int./ext. BMS bus!

The first 16 digital inputs can be configured as "flashing" and in this case are not signalled via
the external BMS. This is only permissible for messages with a flashing frequency of 0.5 Hz!
Inputs that are assigned to operating messages or switching commands are not displayed with a text
message or stored into the history memory.