Bend-Tech Dragon A400, Инструкция по сборке

Страница: 25 / 44

25
Bend-Tech Dragon A400
Assembly Manual
Assembling the Dragon
03
3.6.7 Place and Install the Tail
5
The tail section of the machine comes pre-assembled. Remember to install Swivel Levelers on
the bottom of the two Support Legs before placing and installing the tail.
Use the stainless steel locator pins to align the tail of the machine with the end of the Support
Beam labeled 5. Ensure that there are no gaps between the beam and rail sections.
3.6.9 Position the final Rack
The 5th rack comes pre-installed on the Tail of the machine. Loosen the bolts fastening it to the
support beam. Position it so that the rack butts up against the previous rack. Do not tighten the
rack fasteners yet.
3.8 Secure the Support Beam
3.8.1 Secure the Support Legs
REQUIRED TOOLS & EQUIPMENT
• 3/16 in. Allen Wrench
• Magnetic Tool
Secure the Support Legs to the Support Beams using 1/4 - 20 x 5/8 in Allen head screws and
T-nuts. These can be found in Hardware Bag No. 1. Use the magnetic tool provided, slide the
T-nut behind the Support Leg brace until it aligns with the mounting hole in the Support Leg.
Insert the Allen head screw and thread it into the T-nut, using a 3/16 in. Allen wrench. Repeat
this process for all eight fasteners on each side of the Support Legs.