Bend-Tech Dragon A400, Инструкция по сборке

Страница: 21 / 44

21
Bend-Tech Dragon A400
Assembly Manual
Assembling the Dragon
03
Position Forks Here
Head of Machine
Support the beam when
moving the Head with a forklift.
Installing Swivel Levelers
TOOLS NEEDED
• 9/16 in. wrench
• 5/8 in. wrench
The Installer will be required to
install two Swivel Levelers in
each Support Leg. Each base
of the Support Leg will have a
bracket with a threaded hole.
Prepare the Swivel Leveler for
installation by positioning the jam
nut approximately one inch above
the adjustment hex at the bottom of the Swivel Leveler.
Thread the Swivel Leveler into the threaded hole in the base of the Support Leg
until it bottoms out on the jam nut. This method will place all of the Swivel Levelers
at approximately the same distance, providing a baseline for leveling the machine.
Install Swivel Levelers on each Support Leg as the installation progresses. A 5/8 in.
wrench may be needed to thread the Swivel Levelers into the bottom of the Rail
Support Legs. A 9/16 in. wrench is required to adjust the jam nut.
Swivel
Leveler
Leg Bracket