Bend-Tech Dragon A400, Инструкция по сборке

Страница: 23 / 44

23
Bend-Tech Dragon A400
Assembly Manual
Assembling the Dragon
03
Install the first Support Beam so that the end labeled 3 is closest to the head of the machine.
If necessary, loosen the eight t-nuts that are installed on leg 3, and use a rubber mallet to seat
the Support Beam sections together.
3.6.2 Slide Support Leg #4 into Position
Ensure the Swivel Levelers are installed onto Support Leg #4. Slide it into position at the end
of the first Support Beam, which is labeled 4.
3.6.3 Position the First Rack
Locate the Rack labeled 1 and 2. Align the rack so that the end labeled 1, butts up against the
rack installed on the head of the machine.
4 3 2 1
Note
When positioning and installing the racks, the bolts may need to be loosened. If the bolt is
loosened too much and become separated from the T-Nut, remove the rack completely. Re-
attached the T-Nut, and slide the rack back into position on the extruded aluminum.
3.6.4 Install the Second Beam
Locate the second Support Beam, which will be labeled 4 and 5. Again, use the stainless steel
locating pins on the beam to align the beam when installing it.
Rack Positions