Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
6
MN-1033EN
Donut Robot Mark VI Technical Supplement
WARNING
Never let water and hot shortening come
in contact with each other. Moisture
causes hot shortening to spatter, which
may cause serious injury. Prior to use,
make sure that the kettle and any other
parts you have washed are dry.
After cleaning, assemble the fryer and depositor
as explained below.
Assembling the Fryer
1. Place the fryer case on a flat, stationary
surface.
2. Screw the fryer’s legs in as far as they will
go.
3. Set the kettle into the fryer case. The end of
the kettle that has the locating pin must be
placed at the outfeed end of the fryer case.
The lip of the kettle should fit securely over
the edge of the case.
4. Install the heater head assembly as follows:
a. Align the holes in the heater head end
caps with the holes in the heater head
mounting brackets.
b. Slide the retaining pins through the holes
so that the pinheads are on the outside.
c. Insert the hairpin clips into the holes in
the retaining pins.
5.
Lower the heater head assembly into
position. The thermostat bulb bracket should
rest on or very near the bottom of the kettle.
6. Install the conveyor assembly as follows:
a. Hold the conveyor at the angle shown in
Figure 1-2 and slide the conveyor drive
coupling over the main drive shaft
coupling. The conveyor coupling has a
notch in it. Turn the conveyor coupling
so that the head of the socket head screw
in the motor drive coupling can slide into
this notch. (See Figure 1-2.)
b. Lower the front side of the conveyor
assembly so the hole in the conveyor
flange fits over the locating pin on the lip
of the kettle.
Figure 1-2. Joining the Couplings.
Read steps 7 and 8 only if you are preparing to
make cake donuts using a Donut Robot depositor
(or Dual Depositor). If you are using a Type F
cake donut depositor, refer to the Type F manual.
Figure 1-3. Inserting the Swing Column.
