Belden Hirschmann OWL LTE M12, Руководство пользователя

Страница: 54 / 153

Configuration 4.4 PPPoE Configuration
4.4 PPPoE Configuration
PPPoE (Point-to-Point over Ethernet) is a network protocol which encapsulates PPP frames
into Ethernet frames. The router uses the PPPoE client to connect to devices supporting a
PPPoE bridge or server. The bridge or server is typically an ADSL router.
To open the PPPoE Configuration page, select the PPPoE menu item. If you mark the
Create PPPoE connection check box, then the router attempts to establish a PPPoE connection
after boot up. After connecting, the router obtains the IP address of the device to which it is
connected. The communications from a device behind the PPPoE server is forwarded to the
router.
Figure 24: PPPoE Configuration
Item Description
Username Username for secure access to PPPoE.
Password Password for secure access to PPPoE. Enter valid characters only,
see chap.
1.2.1 !
Authentication Authentication protocol in GSM network.
•
PAP or CHAP – The router selects the authentication method.
• PAP – The router uses the PAP authentication method.
•
CHAP – The router uses the CHAP authentication method.
IP Mode Specifies the version of IP protocol:
•
IPv4
– IPv4 protocol is used only (default).
•
IPv6 – IPv6 protocol is used only.
•
IPv4/IPv6 – IPv4 and IPv6 dual stack is enabled.
Continued on next page
UM Configuration OWL LTE M12
Rel. 06.1.09 - 07/2019
53