Belden HIRSCHMANN MACH 1040 Series, Руководство пользователя

Страница: 6 / 52

6
MACH 1040
Release 02 03/2013

Housing
Only technicians authorized by the manufacturer are permitted to open
the housing.
The device is grounded via a ground connection on the front panel of the
device.

The ventilation slots must not be covered to promote free air
circulation.

The clearance to the ventilation slots of the housing must be at least
10 cm (3.94 in).

Do not touch the housing during operation or shortly after switching off
the device. Hot surfaces can cause injury.

The device must be installed in the horizontal or upright position, either
in the switch cabinet or on the wall
(see page 28 „Installing the
device“) . The device is not intended for operation as a table unit.

Operating the device in the maximum surrounding air temperature and
stacking devices: When installing the device, make sure there is at
least one free rack space (approx. 5 cm) above the device, because
heat is discharged via the housing of the device.

If you are operating the device in a 19" switch cabinet: install sliding/
mounting rails for holding the device
(see fig. 10) .
WARNING
ELECTRIC SHOCK
Never insert any pointed objects (small screwdrivers, wires, etc.) into the
product!
Never insert sharp objects (small screwdrivers, wires, etc.) into the
connection terminals for the supply voltage or the signal contact, and do not
touch the terminals!
Only install this device in a switch cabinet or in an operating site with limited
access, to which only maintenance staff have access.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
WARNING
FIRE HAZARD
Install the device in a fire protected shell if you are mounting it vertically.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.