Belden HIRSCHMANN MACH 1040 Series, Руководство пользователя

Страница: 38 / 52

38
MACH 1040
Release 02 03/2013

Configuration via BOOTP

Configuration via DHCP (Option 82)

AutoConfiguration Adapter
Further information on the basic settings of the device can be found in the
“Basic Configuration” user manual on the CD ROM.

Default settings
 IP address: The device looks for the IP address using DHCP
 Password for management:
Login: user; password: public (read only)
Login: admin; password: private (read and write)

Parameters that can be set via the management are set to pre-defined
values in accordance with the MIB
 V.24 data rate: 9,600 Baud
 Ring redundancy: disabled
 Ethernet ports: link status is not evaluated (signal contact)

Optical 100 Mbit/s ports: 100 Mbit/s, full duplex
All other ports: autonegotiation
 Ring manager disabled
 Stand-by coupling: disabled
Port 4 = control port, port 3 = coupling port for red. Ring coupling

USB interface
The USB socket has an interface for the local connection of an
AutoConfiguration Adapter (part number ACA 21-USB see on
page 48
„Accessories“ ). It is used for saving/loading the configuration and for
loading the software.

V.24 interface (external management)
The V.24 interface is an RJ11 socket.
At the V.24 connection, a serial interface is provided for the local
connection of an external management station (VT100 terminal or PC
with corresponding terminal emulation). This enables you to set up a
connection to the Command Line Interface (CLI) and to the system
monitor.
Figure Pin Operation
1 VCC (VBus)
2 − Data
3 + Data
4 Ground (GND)
Table 5: Pin assignment of the USB interface
1 2
4
3