MACH 1040
Release 02 03/2013
33
Autocrossing (if autonegotiation is activated)
1000 Mbit/s full duplex
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Also for MAR1042 and MAR1142:
Power over Ethernet (PoE, at the first four ports of the device)
The PoE voltage is input via the wire pairs transmitting the signal
(phantom voltage).
State on delivery: autonegotiation activated.
The socket housing is electrically connected to the front panel.
The pin assignment corresponds to MDI-X.
Note:
In general, you should adhere to the following recommendations for
data cable connections using copper in environments with high electrical
interference levels:
Keep the length of the data cables as short as possible. Use optical
cables for the data transmission between the buildings.
Make sure there is a sufficient gap between the power supply cables
and the data cables if they are laid over a long distance. Ideally, install
the cables in separate cable channels.
Use shielded cables.
100 Mbit/s F/O connection
These ports are SFP slots.
100 MBit/s F/O ports enable the connection of terminal devices or
independent network segments in compliance with the IEEE 802.3
100BASE-FX standard.
These ports support:
Full or half duplex mode
State on delivery: full duplex FDX
Figure
Pin
Function For MAR1042 and MAR1142:
Power over Ethernet (PoE)
1
BI_DB +
V -
2
BI_DB -
V -
3
BI_DA +
V +
4
BI_DD +
5
BI_DD -
6
BI_DA -
V +
7
BI_DC +
8
BI_DC -
Table 4:
Pin assignment of a 1000 MBit/s TP interface in MDI-X mode, RJ45
socket - for PoE with the power supplied via the wire pairs transmitting the
signal
8
7
6
5
4
3
2
1
Содержание HIRSCHMANN MACH 1040 Series
Страница 51: ...MACH 1040 Release 02 03 2013 51...
Страница 52: ......
